![]() The -S flag sets the standby/spindown timeout for the drive. There are flags for temperature (-H for Hitachi drives), acoustic management (-M), measuring cache performance (-T), and others. Specify a value of zero (0) to disable the WD idle3 timer completely (NOT RECOMMENDED!). Permitted values are from 8 to 12 seconds, and from 30 to 300 seconds in 30-second increments. Wdidle3 = 300 secs (or 13.8 secs for older drives)Ī setting of 30 seconds is recommended for Linux use. More information about hdparm and smartctl is available on the following sites. If Selective self-test is pending on power-up, resume after 0 minute delay. SMART Selective self-test log data structure revision number 1Īfter scanning selected spans, do NOT read-scan remainder of disk. # 2 Short offline Completed without error 00% 4702. # 1 Short offline Completed without error 00% 5617. Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error SMART Self-test log structure revision number 1 Vendor Specific SMART Attributes with Thresholds: SMART Attributes Data Structure revision number: 16 SCT capabilities: (0x003d) SCT Status supported. Recommended polling time: ( 533) minutes. SMART capabilities: (0x0003) Saves SMART data before enteringĮrror logging capability: (0x01) Error logging supported. ![]() Self-test execution status: ( 0) The previous self-test routine completedĬapabilities: (0x5b) SMART execute Offline immediate.Īuto Offline data collection on/off support. Offline data collection status: (0x80) Offline data collection activity Warning: This result is based on an Attribute check. SMART overall-health self-assessment test result: PASSED SMART Status not supported: Incomplete response, ATA output registers missing SMART support is: Available - device has SMART capability. SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s) Sector Sizes: 512 bytes logical, 4096 bytes physicalĭevice is: In smartctl database ĪTA Version is: ATA8-ACS (minor revision not indicated) Smartctl 7.1 r5022 (local build)Ĭopyright (C) 2002-19, Bruce Allen, Christian Franke, = START OF INFORMATION SECTION = ![]() As mentioned earlier, different systems will generate different outputs. Logical Unit WWN Device Identifier: 500003964bc01970Īn example of a complete smartctl output from a drive is shown below also for reference. more than 508min for ENHANCED SECURITY ERASE UNIT. More than 508min for SECURITY ERASE UNIT. * SMART Command Transport (SCT) feature set * READ_LOG_DMA_EXT equivalent to READ_LOG_EXTĭevice-initiated interface power management * Device automatic Partial to Slumber transitions * Host automatic Partial to Slumber transitions ![]() * Host-initiated interface power management * Device Configuration Overlay feature set R/W multiple sector transfer: Max = 16 Current = 16ĭMA: sdma0 sdma1 sdma2 mdma0 mdma1 *mdma2 udma0 udma1 udma2 udma3 udma4 udma5Ĭycle time: no flow control=120ns IORDY flow control=120ns Standby timer values: spec'd by Standard, no device specific minimum Transport: Serial, ATA8-AST, SATA 1.0a, SATA II Extensions, SATA Rev 2.5, SATA Rev 2.6, SATA Rev 3.0ĬHS current addressable sectors: 16514064
0 Comments
Leave a Reply. |